ARES 506-606 - 02.2005 - GB
G.7
UPPER LIMIT
This limits the top part of the linkage travel to prevent large
implements touching the cab or while shaft-driven implements
are being used.
- Set the mode selector (1) to high position (II).
- Adjustment is by the keys (9) "+" and "- " after requesting the
top limit function with key (7).
- As soon as the top limit function is selected (key 7), the
adjustment value appears on the display (4) (opposite is an
example of adjustment: top limit set at 98).
The adjustment operates on the upper part of the linkage travel
between points 50 (mid travel) and 100 (max limit) in steps of 1.
Note: When adjustment is completed the display
automatically returns to position mode.
Note: The top limit position will never be exceeded by
another linkage command (position, force or external
controls).
LOWERING SPEED
- Adjustment is possible as long as the mode selector (1) is not
in the transport position (I).
- This is adjusted using keys (9) "+" and "-" after requesting the
rate of descent function with key (8).
- As soon as the lowering speed function is selected the
adjustment value appears on the display (4) (opposite is an
example of adjustment: rate of descent set to 80).
Note: If keys (9) are not used the screen returns to position
display after 5 seconds.
Adjustment is on a scale of 10 to 100 in steps of 10:
= slow rate of decent.
= fast rate of descent.
Note: When adjustment is finished, press the lowering
key (8) to return to position display.
Important: Before any heavy implement is lowered to hard
ground, set the lowering speed on value "10".
382hsn07
382hsn08
382hsn09
To Next Page
Loading...
