ARES 506-606 - 02.2005 - GB
G.11
MODE SELECTOR
HIGH POSITION (I)
The linkage is positioned during a manoeuvre on the top limit
programmed by the adjustment button (7).
STOP POSITION (II)
This position stops the linkage at any time in its travel.
Note: Light upward or downward pressure on selector (1)
allows the height of the linkage arms to be precisely
adjusted from the STOP position.
WORKING POSITION (III)
In this position the linkage arms will descend to the position
chosen for operating the implement.
FAST SOIL ENTRY POSITION (IV)
The mode selector on position (IV) gives a faster implement soil
entry.
TRAVELLING POSITION
This mode maintains the linkage in high position, the electronic
box preventing any wrong manoeuvres during road transport (red
light (6) on). This active position also activates the travel damper.
To activate the travelling position:
- Set the selector (1) to top limit (I).
- Press the key (4). The safety warning light (6) comes on.
- To de-activate the travelling position, press once more the key
(4). Then perform the "linkage initiation procedure" to
make it operational.
382hsn24
382hsn27
1
7
46
To Next Page
Loading...
