FreeSpeak Edge | User Guide
3.3.1 Guidelines
l Transceiver RF coverage zones ideally overlap by 20% of the coverage cell
l If transceivers are 3m (10 feet) or less apart, for best performance, Clear-Com
recommends that adjacent transceivers do not use adjacent channels. Without this gap
between channels and transceivers, there is some possibility of interference.
l Beltpacks must not see the same channel on more than one transceiver at any one time.
l Adjacent transceivers can use the same channels if the channel order is reversed. For
example; transceiver A, Channel 1 = 36, Channel 2 = 64. Transceiver B, Channel 1 = 64,
Channel 2 = 36. However, the set up point above, (beltpacks do not see more than one
transceiver with the same channel at any time) is preferred.
Page 16
To Next Page
Loading...
Need help?
General
