EasyManua.ls Logo

Clear-Com FreeSpeak Edge - Transceiver Connector Panel; Powering the Transceiver

Clear-Com FreeSpeak Edge
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FreeSpeak Edge | User Guide
7.2 FreeSpeak Edge transceiver connector panel
7.3 Powering the transceiver
The transceivers can use:
l Power over Ethernet (PoE). Connect to LAN 1 RJ45.
Note: The transceiver is a Class 3 PoE device.
l Local power. Use the supplied power supply (12V DC 5 amp).
l USB power from a USB battery pack. For standalone mode, this is 3 A, 5V.
7.3.1 Power redundancy
You can simultaneously power the FreeSpeak Edge transceiver using a local power supply and
PoE. In this case, the following applies:
l If the transceiver is using a local power supply, adding a PoE connection causes no
power interruption.
l If the transceiver is using a PoE connection, adding a local power supply interrupts the
power supply for 1 to 2 seconds.
l If the transceiver is using both local and PoE, if you remove the local power supply
connection, the power supply is interrupted for 1 to 2 seconds and then continues using
the PoE supply.
l If the transceiver is using both local and PoE, if you remove the PoE connection, the
transceiver continues to operate without interruption using the local power supply.
Page 72

Table of Contents

Other manuals for Clear-Com FreeSpeak Edge

Related product manuals