FreeSpeak Edge | User Guide
The upgrade will begin automatically when you insert the USB stick.
Note: Both status LEDs will flash light blue once per second for 5 seconds on successful detection of
the upgrade file. Both status LEDs will light solid red if there is an error during the upgrade.
When upgrade is complete, both status LEDs will flash green.
8.2 Upgrading FreeSpeak Edge beltpacks
You can upgrade the FreeSpeak II beltpack firmware by:
l
l Upgrading from the EHX PC using USB cable (the file extension for the upgrade
firmware is .ccu)
l Using an Over The Air upgrade.
8.2.1 Upgrading from the EHX PC using USB cable
1. Connect the beltpack to a USB port on the computer running the EHX software.
2. Select Tools > Apply Wireless Firmware Via USB.
3. Browse to the location of the upgrade file, and then select Update Firmware. The upgrade
file for USB has a .ccu extension.
The upgrade file is downloaded to the beltpack or transceiver.
Note: FreeSpeak Edge beltpacks must be upgraded individually.
8.2.2 Upgrading beltpack firmware by Over The Air Upgrade
Note: The Beltpack file is first sent to the transceiver(s) before being sent over the air to the
beltpacks
Note: When enable OTA registration on the beltpack is on, upgrade is disabled. Upgrade is re-
enabled when registration is finished.
Note: When using OTA upgrade, the FS Edge beltpacks are all upgraded at the same time.
Note: For OTA upgrade, the beltpack must be within 15- 20 meters (50 to 66 feet) of the
transceiver.
1. Right-click on the Frame in the Layout window, and then select Firmware > Update
Firmware. The Update Firmware Wizard appears.
Page 80
To Next Page
Loading...
Need help?
General
