FreeSpeak Edge | User Guide
Note: When powered by USB, RF is active on the beltpack and audio can be transmitted. This is not
the case when the beltpack is in the charging cradle.
To use the power button, the USB and the cradle must be disconnected and a properly charged
battery must be inserted.
Shut down
As well as using the power button, beltpack can also be shut down using the 'shutdown' option
in the Administration menu.
Note: The beltpack will only shut down if the USB and the cradle are disconnected, otherwise it will
reboot.
6.5 Menu mode
Although the beltpack is controlled from the EHXconfiguration software by default, it also has
a menu system available in the beltpack display screen.
Menu mode can be accessed by pressing either of the + -buttons situated on the front of the
beltpack just behind each of the rotary controllers simultaneously.
6.6 Use/persist local settings (beltpacks)
Beltpack preferences, for example; volume, sidetone, alert behavior and display brightness, are
centrally controlled by the configuration software. These variables can be changed on the
beltpack using the beltpack menu system, but they will not persist over power cycles. To save
your beltpack preferences through power cycles use the Use/Persist Local Settings feature.
6.6.1 Enable Use/Persist Local Settings (EHX)
1. In the EHXsoftware navigate to: Matrix>Configuration>Beltpack
Roles>Beltpack>Preferences>Menu Options>Persist Local Settings.
2. Click to check Persist Local Settings.
Page 53
To Next Page
Loading...
Need help?
General
