FreeSpeak Edge | User Guide
8 Upgrading FreeSpeak Edge
This section tells you how to upgrade your transceiver and beltpacks.
8.1 Upgrading FreeSpeak Edge transceivers
You can upgrade the transceiver firmware by:
l Upgrading from the matrix (the file extension for the upgrade firmware is .ccf)
l Using a USB memory stick (the file extension for the upgrade firmware is .ccf)
8.1.1 Upgrading from the matrix
1. Right-click on the Frame in the Layout window, and then select Firmware > Update
Firmware. The Update Firmware Wizard appears.
2. Select Next. The following screen appears:
Note: For the Edge transceivers, the Auto/Promoted radio button is always set to Auto.
3. Select the Wireless radio button.
4. Select Next, and then browse to the upgrade file (.ccf) and select Open. The upgrade file is
loaded to the transceiver, and the transceiver restarts.
You can track the status of the download in the EHX Event Log.
8.1.2 Upgrading by USB memory stick
Place the *.ccf upgrade image onto a USB stick in a folder named
firmware_upgrade
located in
the root of the USB FAT32 file system.
Note: Make sure that there is only one upgrade image in the folder. If not, the incorrect image might
be upgraded.
Page 79
To Next Page
Loading...
Need help?
General
