FreeSpeak Edge | User Guide
Note: After using a beltpack with a transceiver in Standalone mode, you will need to re-register the
beltpack to the matrix system.
4.2 Local RF scan using a beltpack
Your Edge beltpack has the capacity to conduct an RF scan of the local environment, in order
to find out which 5GHz channels on your site are available and do not contain RF traffic. When
you put a beltpack in Channel Scan mode, it reboots in a mode that can see the local RF
environment. Audio and BLEare not available.
4.2.1 Put the beltpack into Channel Scan mode
1. Power on the beltpack.
2. Enter menu mode by pressing the + and - keys at the same time for one second.
3. Navigate to Diagnostics using the rotary controllers.
4. Select Diagnostics using the D key.
5. Navigate to Channel Scan using the rotary controllers.
6. Select Channel Scan using the D key.
7. You will be asked to confirm that you want to reboot the beltpack in Channel Scan mode.
8. Press the D key to enter Channel Scan mode.
9. The beltpack will reboot in Channel Scan mode.
Note: Use the C key to go back or cancel.
4.2.2 Using Channel Scan mode
A semi-opaque rectangle moving across the screen shows channels being scanned.
Use the + and - keys to move through the region filters (All, EU, CA, US).
Note: It is important that you select the correct region.
Page 24
To Next Page
Loading...
Need help?
General
