FreeSpeak Edge | User Guide
Note: As with all Eclipse Cards, the front card is hot-swappable, but the backplane card connector is
not. When putting the cards back onto a matrix, as well as when you remove it, the frame's
power must be turned off.
5.5 Adding an E-IPA-HX card to the software
To add and E-IPA-HX card to the software:
1. In the EHX configuration software go to: Hardware > Cards and Ports, and then navigate to
an available slot number (marked Empty). Do either of the following:
a. Double click the slot.
b. Right click the slot and select Set Card Type.
2. Select a card type from the drop-down menu listing the available card types.
Note: You should not have both E-IPA-HX cards and E-QUE-HX cards on the same matrix. This
restriction is to prevent users installing and using E-QUE-HX FreeSpeak 1.9 transceivers and E-
IPA-HX FreeSpeak 1.9 transceivers on the same matrix.
5.6 Configuring the E-IPA-HX card for FreeSpeak Edge
Note: For use with FreeSpeak Edge you must have EHX v. 12 or above.
Note: For more information about using the EHX configuration software to setup and configure the IP
transceiver, see the EHX Configuration Software User Guide.
5.6.1 Set card properties
Configure the network settings in Card Properties. Navigate to
EHX>Matrix>Configuration>Hardware>Cards and Ports. Select the E-IPA card by clicking on it
then right click to access Card Properties.
Page 31
To Next Page
Loading...
Need help?
General
