FreeSpeak Edge | User Guide
5.8.2 Cabling the FreeSpeak Edge TCVR
Run Ethernet cable from one of the LAN connectors on the E-IPA card (default AES67
connector = LAN 3) to connect the FS Edge TCVR to the same properly configured IP network.
5.9 Adding transceivers to the matrix
When at least one beltpack has been allocated to the card, you will see a Transceivers button
appear under Hardware. Click this button to add and remove IP transceivers.
Two methods can be used for adding transceivers;
1. Online configuration (the Discovery method)
2. Offline configuration
Once connected, you can allocate static IP addresses to the transceiver if you wish.
5.9.1 Online configuration (the Discovery method)
Use Detect IP TCVR to find the transceivers on the network. The AES67 interface of the E-
IPA-HX card and the transceivers must be on the same network. The EHX software must be on
the same network as the E-IPA Admin port.
By default, the E-IPA-HX and the Edge transceiver are in DHCP mode.
Note: The Detect IP TCVR feature works if the EIPA card Admin LAN port (LAN1 by default) and the
transceivers are not on the same subnet.
Page 38
To Next Page
Loading...
Need help?
General
