FreeSpeak Edge | User Guide
Table of contents
1 Important Safety instructions 6
1.1 Safety symbols 7
2 Introduction to FreeSpeak Edge™ 8
2.1 FreeSpeak Edge 5 GHz 8
2.2 System capacity 9
3 RF channel selection 5 GHz 10
3.1 Channel selection 13
3.2 Transceiver Power 14
3.3 Channel re-use 15
3.4 Using Dynamic Frequency Selection (DFS) channels 17
3.5 Radar scanning in DFS channels 18
3.6 Transceiver - excluded channels 19
3.7 Wireless Regulatory Region (WRR) 20
3.8 Change RF channels on the Edge transceiver 21
4 Site survey features 23
4.1 Transceiver standalone mode 23
4.2 Local RF scan using a beltpack 24
5 Installing FreeSpeak Edge 26
5.1 Installing the FreeSpeak Edge transceiver 26
5.2 Clear-Com cable recommendations 28
5.3 Daisy-chain transceivers 29
5.4 Installing and removing an E-IPA-HX card 30
5.5 Adding an E-IPA-HX card to the software 31
5.6 Configuring the E-IPA-HX card for FreeSpeak Edge 31
5.7 Beltpack roaming between E-IPA-HX cards 33
5.8 Connecting the FreeSpeak Edge transceivers to a matrix 34
5.9 Adding transceivers to the matrix 38
5.10 Beltpack roles 44
5.11 Registering the beltpack to a matrix 46
5.12 Connect the beltpacks 48
5.13 De-register beltpacks from a system 48
6 Operating the Edge beltpack 50
6.1 Top controls and display 50
6.2 Front controls 51
Page 3
To Next Page
Loading...
