FreeSpeak Edge | User Guide
9. Click the tick or cross icon to accept or discard changes.
10. Click Close.
11. Click Apply Map to Matrix.
5.10 Beltpack roles
Beltpack roles are used to define your Edge beltpack properties and audio configuration. Roles
should be created in your configuration software before you connect your beltpacks to the
system.
Once a role has been generated in EHX, audio and keys can be configured in the panel
programming screen. This role can then be fixed to the beltpack so it persists over power
cycles, or you can allow a role to be selected by the beltpack user.
To create a role, navigate to EHX>Matrix>Configuration>Beltpack Roles. Click New FS Edge
Role.
Page 44
To Next Page
Loading...
Need help?
General
