6.Applicable documents
Credentialed OTTO platform users can learn more on the OTTO Support Center (login required). If access
is required, contact OTTO Motors Support and they will be happy to answer any questions or provide
access.
Reference Number
OTTO 600 operation and maintenance manual OMM-000117
OTTO 600 stability and center of gravity Available upon request
OTTO 600/1200 Fast Charger operation and maintenance manual OMM-000119
OTTO 600 attachment interface Available upon request
Standard OTTO 600 safety configuration 031684
OTTO 600 sensor footprint and mechanical interface Available upon request
LiDAR safety scanner operating instructions -
Manual charger operating instructions -
7.In case of a collision
Cease operation
1. Stop the AMR by pressing an Emergency Stop button on the AMR or an equipped attachment.
IMPORTANT
For emergency stop button locations, refer to the Components overview [26]
section of the AMR operation and maintenance manual.
2. Is anyone hurt? Administer first aid immediately. Seek medical attention if necessary. Follow
workplace injury and accident reporting procedures.
Document the incident
1. Follow the facility's workplace health and safety procedures for incident reporting.
2. Interview any witnesses.
3. Note the time and place.
4. Note which AMR was involved.
5. Take photos or make a drawing.
6. If the AMR is connected to OTTO Fleet Manager, create a manual snapshot to capture diagnostic
information and AMR sensor data to assist OTTO in diagnosing the incident cause.
Inspect the AMR
1. Shut down the AMR.
2. Remove the AMR from any high traffic areas.
3. Visually inspect the AMR for damage and take photos of any damage found.
OTTO 600 - OMM-000117-A
© Clearpath Robotics Inc. 2024. All rights reserved. CLEARPATH and OTTO are trademarks of Clearpath Robotics Inc.
All other product and company names listed are trademarks or trade names of their respective companies. 23
To Next Page