CAUTION
•
IMPACT HAZARD! Always maintain a safe distance from an AMR in operation. An
AMR being operated in manual mode should only be operated by personnel who
have been trained and authorized according to the standards of the facility in which
the AMR is in use. Be aware of the emergency stop button locations. For button
location information, refer to the components overview section of the AMR operation
and maintenance manual.
•
IMPACT HAZARD! While driving the robot in manual mode, the safety field sets
monitored by the LiDAR scanners can be disabled. To avoid impact, be aware of the
robot's surroundings.
•
Avoid making contact with the LiDAR safety sensors as they are fragile and easily
damaged. For sensor locations, refer to the components overview section of the AMR
operation and maintenance manual.
•
Do not expose the product for a prolonged period to temperatures outside the
ranges specified in the product documentation.
•
IMPACT HAZARD! Do not place anything on the robot that extends beyond
its footprint. Refer to the robot Safety Configuration document for the footprint
dimensions.
•
CRUSH or IMPACT HAZARD! Keep low profile objects that the LiDAR cannot detect,
such as forklift tines and pallets, outside of the robot's path. For sensor layouts, refer
to the Component Overview section of the AMR operation and maintenance manual.
•
BURN HAZARD! Allow the product to cool before performing maintenance.
•
Do not connect the AMR to a manual charger and an automatic charger at the same
time as this can result in damage to either charger.
•
SHOCK HAZARD! Improper use or maintenance of robot batteries may result in a
high energy discharge.
•
Never exceed the maximum total payload constraints of the product. For payload
constraints, refer to the System Specifications for the product.
•
CRUSH HAZARD! Objects can fall from the product. Only interact with the product on
level floors and when possible, secure loads to the product toavoid objects falling,
tipping, shifting, or sliding.
Charger hazards
For instructions on connecting the robot to a charger, refer to the charging information in the Basic Usage
section of the product operation and maintenance manual.
OTTO 600 - OMM-000117-A
© Clearpath Robotics Inc. 2024. All rights reserved. CLEARPATH and OTTO are trademarks of Clearpath Robotics Inc.
All other product and company names listed are trademarks or trade names of their respective companies. 8
To Next Page