CAUTION
Only use the attachments, accessories, tools, replacement parts, and cleaning products
approved by OTTO.
1. Lock-out/tag-out the AMR.
2. Inspect LiDAR safety scanner and, if applicable, the LiDAR cavity with a flashlight for any dust and/or
debris.
3. Using the lens cleaning wipes, clear the LiDAR cavity of any dust/debris. Clean the LiDAR and the
cavity with different wipes.
13.Disposal
Always observe valid environmental protection regulations.
If disassembling the product for disposal, pass on any commercially-viable disassembled components for
recycling. Separate materials as far as possible by type.
Do not incinerate or dispose of the batteries. Return end-of-life or defective batteries to the nearest
recycling center per appropriate local regulations.
Waste material like oil must be properly disposed of and recycled according to regulations and, if
necessary, brought to a recycling center.
14.Troubleshooting
This section lists possible issues that may be encountered when using the product.
If there is a malfunction and the AMR cannot be operated out of the working zone, refer to Basic
Usage [38] for instructions on safely moving it.
Observation Issue Resolution
AMR is in emergency
stop state
Confirm light pipe/
speaker indicate
emergency stop state
1. Eliminate the reason for the emergency stop.
2. Press the Reset button.
3. Press the Start button.
AMR is in a safety stop
state
Confirm light pipe/
speaker indicate safety
stop state
• Eliminate the reason for the safety stop. The AMR will operate
again automatically.
AMR is not moving
autonomously
AMR is disconnected
from the WiFi network
1. Confirm the AMR can be controlled through OTTO App and/or
OTTO Fleet Manager.
2. Confirm in OTTO App and/or OTTO Fleet Manager that the AMR
has no current Job.
If there is no current Job is assigned to the AMR and it is parked, it
is not expected to move.
3. Restart the AMR.
AMR has no currently
assigned Job
AMR stationary in or in
front of a dock
AMR is in an emergency
or safety stop state
1. Eliminate the reason for the emergency stop or safety stop.
OTTO 600 - OMM-000117-A
© Clearpath Robotics Inc. 2024. All rights reserved. CLEARPATH and OTTO are trademarks of Clearpath Robotics Inc.
All other product and company names listed are trademarks or trade names of their respective companies. 50
To Next Page