The mechanical interface covers the following load handling attachments as standard:
•
• Lifting table
• Roller conveyors
Load handling attachments that deviate from the standard specification are considered special load
handling attachments and must be technically tested individually.
IMPORTANT
For more information on possible load handling attachments, contact the manufacturer's
service department.
Electrical interface
The electrical interface consists of prefabricated module plugs. It is used for both communication and
power supply to the load handling attachment.
Safety-relevant signals (such as STO outputs, hot-stop inputs, load presence detection) are connected
directly to the safety controller via the electrical interface.
In the standard version, the electrical interface covers the following load handling attachments and
functions:
OTTO 600 - OMM-000117-A
© Clearpath Robotics Inc. 2024. All rights reserved. CLEARPATH and OTTO are trademarks of Clearpath Robotics Inc.
All other product and company names listed are trademarks or trade names of their respective companies. 30
To Next Page