CME BodyGuard 595 Color Vision - Pump Specifications

6 – Specifications
BodyGuard 595™Color Vision Operator Manual
65
6 – Specifications
Pumping Mechanism:
Piston Pump
Flow Rate:
0 to 100 ml/hr in 0.1ml increments (depends on infusion modes)
Priming Rate:
1000 ml/hr
Total Infused Volume:
0.1 to 1,000 ml.
Accuracy:
±5%
KVO rate:
0.1 to 5 ml/hr
Air Sensor:
Ultrasonic, adjustable air bubble size
Maximum Pressure:
Adjustable for each protocol based on infusion mode:
PCA
250-520mmHg
Epidural
350-1100mmHg
Regional
350-1800mmHg
Power Supply:
Power Supply 100 – 240V AC, 50/60 Hz (10W / 0.3A)
Battery:
Rechargeable Li-Polymer 7.4V 1800 mAh. (Typical)
Battery Operation
at 125 ml/hr:
17 hours (Rechargeable)
Battery Charging:
Automatic when clicked into the Charger that is connected to an
AC power source. Six hours needed to charge a fully-depleted
battery.
Alarms:
When a problem is detected, the BodyGuard 595 Color Vision™
displays the following alarms:
 Air in line
 Down/Up Occlusion
 End of infusion
 Low Battery
 End Battery
 Pump Unattended
 Door Open
 Lock Mode
 Missing Key
 Check Program

NOTE: when this symbol is seen, consult accompanying documents.
BodyGuard 595 Color
Vision™ Dimensions:
112 x 89 x 40mm. (L x W x H).