Code Reader 1200 User Manual

C001537_04_CR2 User Manual - 25
Save Settings
4.1 - Introduction
The following chapter will allow a user to change the symbology settings on the CR2. To reset the unit to
factory defaults or to save the current settings please scan one of the codes below:
Save Settings Reset to USB Factory Defaults Reset to PS/2 Factory Defaults
Reset to RS232 Reset to RF One Way Clear All CodeXML Rules
Factory Defaults Factory Defaults
Readers are shipped at manufacturing with default communication settings that are hardware dependent.
Note: If you do not save your settings and the CR2 loses power you will lose your settings.
4.2 - Aztec Symbology
Scan the following codes to enable/disable Aztec symbology settings:
Aztec On Aztec Off (Default) Sample Aztec Code
4.3 - Codabar Symbology
Scan the following codes to enable/disable Codabar symbology settings:
Codabar On (Default) Codabar Off Sample Codabar
Radio settings will
not be reset with
this code.
Radio settings will
not be reset with
this code.
Radio settings will
not be reset with
this code.
Feature not yet available.

Code Reader 1200 Specifications

General

Brand	Code
Model	Reader 1200
Category	Barcode Reader
Language	English