C001537_04_CR2 User Manual - 68
Save Settings
11.6 - CR2 Maintenance
The CR2 device operates efficiently and reliably and needs only a minimum of maintenance to
operate. A few tips are given below for maintenance suggestions.
Cleaning the CR2’s Window
The CR2’s window should be clean to allow the best performance of the device. The
window is the clear plastic piece inside the head of the Reader. Do not touch the window. Your
CR2 uses CMOS technology that is much like a digital camera. A dirty window may stop the CR2
from reading codes.
If the window becomes dirty, clean it with a soft, non-abrasive cloth or a facial tissue (no lotions or
additives) that has been moistened with water. A mild detergent may be used to clean the window,
but the window should be wiped with a water moistened cloth or tissue after using the detergent.
The CR2’s housing may be cleaned in the same way.
For applications that require cleaning with disinfectant, please use products with the following
ingredients:
1) Isopropyl Alcohol
2) Ethyl Alcohol (Denatured Grade)
Code does not recommend using bleach.
Technical Support and Returns
For returns or technical support call Code Technical Support at (801) 495-2200.
For all returns Code will issue an RMA number which must be placed on the packing slip when the
reader is returned.
Warranty
Please refer to the CR2 User Manual for warranty policy.
To Next Page
Loading...
Need help?
General
