C001537_04_CR2 User Manual - 63
Save Settings
11.1 - Reset Reader to Factory Defaults
Scan the following codes to reset reader:
Reset to USB Factory Default Settings Reset to PS/2 Factory Default Settings
Reset to RS232 Factory Default Settings Reset to RF One Way Factory Default Settings
Clear All CodeXML Rules Clear All Stored Data Save Settings Code
Prefix & Suffix
Note: If you scan the following codes, you may lose your current settings. Make sure to save settings
on your reader before scanning the above codes.
11.2 - General Safety Information
Repairs and Adjustments - Only those individuals authorized by Code should attempt to make
repairs or adjustments to CR2 equipment. If the reader casing is opened the warranty is voided
Power Supply - Use only the particular power supply provided for use with a specific unit when
operating Code equipment.
Accessories - Only those accessories approved by Code (page 9) should be utilized with Code
equipment. Non-compliance with any of the above may result in:
• Injury to individuals handling the equipment
• Damage to the equipment
• Voiding of the maintenance contract
Lasers - The CR2 utilizes a laser FOR TARGETING PURPOSES ONLY.
If the laser is activated, do not stare into the beam.
Radio settings will
not be reset with
this code.
Radio settings will
not be reset with
this code.
Radio settings will
not be reset with
this code.
Feature not yet available.
To Next Page
Loading...
Need help?
General
