coM.sat ISDN Basic
created: page: file:
16/01/09 47 coMsat ISDN Basic Manual V2.7.doc
Note Protection Mark according to DIN 34!
network as all three functions so that it may take 20 seconds or more. As a result of
the query, the number redirected to is shown in field ”Redirect to” or a message
reports that there is no diversion. To program a diversion, first enter the number that
is to be redirected to and then push the butten ”Set”. About 20 seconds later, the
positive or negative operation result is displayed. Pressing the button ”Delete”
causes the call diversion to be deleted.
The second possible call diversion by the coM.sat ISDN Basic offers the possibility to
call a different number immediately or after timeout if a specific MSN is called. For
each diversion, an entry must be programmed in the table that contains the called
MSN, the number to redirect to, the route to be used and the duration of the alerting
before redirecting. The MSN must be programmed without PBX number. The
redirected call may use GSM, fixed network or PBX as destination or the destination
can be determined by the routing table. This is programmed with the shortcuts “g”, “i”,
“p” or “r”, which are automatically expanded in the table. The timeout may be set to 0
which means the call shall be redirected immediately. If the value is not 0, it
determines how many seconds the original extension is alerted before the call is
redirected.
It is possible to program multiple redirections for a single MSN. To do this, simply
enter one line for each redirection all with the same MSN. These lines are processed
from top to bottom, i.e. the first entry is used as first redirection. If that redirected
number also does not accept the call, it is redirected to the number in the next entry.
Keep in mind that in this case, a timeout of 0 (immediate redirection) may only be
used for the first entry. Following redirections only make sense if they are alerted for
some time before redirected again.
If a called number is busy and there is a diversion programmed, the redirection is
immediately started after it is reported busy.
Note: This function is only activated if there is a valid Basic Pro license (see 3.3.15).
To Next Page
Loading...
Need help?
General