coM.sat ISDN Basic
created: page: file:
16/01/09 37 coMsat ISDN Basic Manual V2.7.doc
Note Protection Mark according to DIN 34!
3.3.7 Fax/Data
Figure 13: Fax/Data
This page allows the configuration of data and fax connections. Since the coM.sat
ISDN Basic has no built-in analogue modem, it is not possible to set up data or fax
connections via ISDN and therefore the options for these kind of calls are disabled.
The coM.sat ISDN Basic is able to exchange data and faxes by the use of a PC. In
this case, the connected PC must have suitable software for fax or data which is
ready to receive incoming calls. To enable this, ”Data Calls to PC” and/or ”FAX
Calls to PC” must be enabled. Then the coM.sat ISDN Basic behaves like an
analogue modem on its serial interface, i.e. incoming calls are reported with a ”RING”
To Next Page
Loading...
Need help?
General