coM.sat ISDN Basic
created: page: file:
16/01/09 21 coMsat ISDN Basic Manual V2.7.doc
Note Protection Mark according to DIN 34!
current actions. The state of the link (online/offline) and the port of the PC via which
the data is transmitted when a link is made (e.g. “Online (COM 1)”) is displayed on
the left-hand side of the bar.
The ”Connection” menu contains another command, i.e. ”Automatic Load”. This
command opens the following dialog:
Figure 7: Automatic Load
As long as this dialog is open, coMsat.exe checks the messages from the device
and starts an automatic load if it reports a restart. It can load the monitor and the
statistics as selected by the first two options.
The load process can also be started periodically. To enable this, the option “Load
every … minutes” must be activated and the period set as desired. The automatic
can load the monitor, the statistics and the status information as selected by the
options. The statistics can only be loaded if the license for extended funktions is
available, otherwise the option is disabled.
If the automatic load is done for monitoring a long period, the load timeout should last
3 – 5 minutes in order not to loose information. If only statistics is loaded, 1 hour is
sufficient. To load the statistics, a login must be possible so the passwords must be
entered correctly. The automatic load function logs in before loading the statistics,
even if already logged in. This is done because a restart might have caused a logout
and then the statistics could not be loaded anymore.
To Next Page
Loading...
Need help?
General