ComAp InteliDrive Lite

ID-FLX Lite & Telecom Global Guide
100
Setpoint group Basic settings Related FW 2.5.0
Range [units] [OFF, MAN, AUT]
Default value -
Step -
Comm object 8315 Related applications
Description
Equivalent to Controller mode changes by MODE→ or ←MODE buttons.
Note: Controller Mode change can be separately password protected.
ControllerMode
6 back to List of setpoints
Setpoint group Basic settings Related FW 2.5.0
Range [units] [ENABLED, DISABLED]
Default value -
Step -
Comm object 9983 Related applications
Description
DISABLED Controller stays in AUT mode after Fault reset. Default state.
ENABLED
Automatic switch from AUT to MAN mode after Fault reset to avoid automatic engine start.
This function is active for Shut down protection only.
FltResGoToMAN
6 back to List of setpoints
Setpoint group Basic settings Related FW 2.5.0
Range [units] 0 .. 60 [min]
Default value
0 … means that the
display lights all the
time
-
Step 1 [min]
Comm object 10121 Related applications
Description
The display backlight is switched off after timeout.
DispBacklightTO
6 back to List of setpoints
Setpoint group Basic settings Related FW 2.5.0
Range [units] [Nom/Idle, N/I Init, Conveyor, RegReqst, R RegDis, CloseLoad, Toggle]
Default value -
Step -
Panel Button