ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
344
Setpoint group CM-RS232-485 Related FW 1.9.0
Range [units] 9600 / 19200 / 38400 / 57600 / 115200[bps]
Default value 57600 bps Alternative config NO
Step [-]
Comm object 24341 Related applications AMF, MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint COM1 Mode (page
343)
Description
If the direct mode is selected on COM1 channel, the direct communication speed of controller part of line can
be adjusted here. Speed of second part of line has to be adjusted to the same value.
Note: Winscope supports only 19200, 38400, 57600 speeds.
COM1 Communication Speed
6 List of setpoints (page 170)
Setpoint group CM-RS232-485 Related FW 1.9.0
Range [units] 9600 / 19200 / 38400 / 57600 / 115200 [bps]
Default value 9600 bps Alternative config NO
Step [-]
Comm object 24477 Related applications AMF, MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint COM1 Mode (page
343)
Description
If the MODBUS mode is selected on COM1 channel, the MODBUS communication speed can be adjusted
here.
COM1 MODBUS Communication Speed
6 List of setpoints (page 170)

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65