Powering supply from the mains: features and connection
42
HS-RC-C5E-TIN_03.fm
00/0211
Follow-up procedure
Do not turn on the main switch to power the Control Unit until the
installation procedure is completed.
If a different fitting point is required for the cable, the in-fitting hole
shall not be left open.
To serve this puerpose, install anyway the plate with the cable gland.
Also, fit a plug (e.g. a plug Hummel code 1.296.2101.11, not part of the
supply volume) in the cable gland hole.
To Next Page
Loading...