3.5.3 Pause Time
Description: During auto dials and speed dials, it is sometimes necessary to delay the sending of digits
to give switching equipment time to prepare for receiving them. A pause is stored for this
purpose whenever the user presses the HOLD button. You can set the length of the pause
with this programming feature.
To Program: 1. Dial 13. “PAUSE TIME XXX”
2. Select time.
—Dial 1 or Press A1 “PAUSE TIME 0.50”
—Dial 2 or Press A2 “PAUSE TIME 1”
—Dial 3 or Press A3 “PAUSE TIME 1.50”
—Dial 4 or Press A4 “PAUSE TIME 2”
—Dial 5 or Press A5 “PAUSE TIME 3”
—Dial 6 or Press A8 “PAUSE TIME 5”
—Dial 7 or Press A9 “PAUSE TIME 7.50”
—Dial 8 or Press A10 “PAUSE TIME 10”
—Dial 9 or Press A11 “PAUSE TIME 15”
—Dial 0 or Press A12. “PAUSE TIME 20”
3. Dial ✳ for configuration mode.
To change setting, repeat procedure and make different selection.
3.5.4 Recall/Flash
Description: The system can generate either a line disconnect (recall) or a host system feature access
signal (flash) depending upon the programmed time.
To Program: 1. Dial 12. “RECALL/FLSH XXXX”
2. Select time.
—Dial 1 or Press A1 “RECALL/FLSH 0.08”
—Dial 2 or Press A2 “RECALL/FLSH 0.30”
—Dial 3 or Press A3 “RECALL/FLSH 0.50”
—Dial 4 or Press A4 “RECALL/FLSH 0.60”
—Dial 5 or Press A5 “RECALL/FLSH 0.75”
—Dial 6 or Press A8 “RECALL/FLSH 0.88”
—Dial 7 or Press A9 “RECALL/FLSH 1”
—Dial 8 or Press A10 “RECALL/FLSH 1.50”
—Dial 9 or Press A11 “RECALL/FLSH 2”
—Dial 0 or Press A12. “RECALL/FLSH 3”
3. Dial ✳ for configuration mode.
To change setting, repeat procedure and make different selection.
Digital Telephone System IMI66–107
3 – 34 System Programming
To Next Page
Loading...