3.7.13 Flexible Station Numbering
Description: The system supports a flexible station numbering plan for calling individual stations and
departments. You can program each station port to respond to the dialing of any available
number between 10 and 7999; however, the system will not allow you to assign the same
dialing code as both a station extension number and a department access code, nor will
the system allow you to assign an extension number or access code conflict such as 15
and 1500.
To Program: 1. Dial 52. “ACCESS CODE”
2. Dial 1 to assign extension number. “ASSIGN EXT. NUM”
3. Select station port “EXT. XXXX ”
—Station 10–57 = Dial 10–57 or press C10–C57.
4. Dial new extension number. “EXT. XXXX YYYY ”
NOTE: Extension number can be max. of four digits. If less than four digits, leading
zeros must be dialed before number. (Example: For ext. no. 15, dial 0015).
5. Select next station number and assign extension number
—OR—
dial ✳ for configuration mode.
To change setting, repeat procedure and make a different selection.
3.7.14 Group Call Pickup
Description: If a call rings to any station in a prearranged group, a user at another station in that group
can dial a group pickup code and answer the call. Assign the stations to call pickup
groups using this procedure.
To Program: 1. Dial 53. “STATION FEATURES”
2. Dial 16. “GRP. CALL PICKUP”
3. Dial 0 for no group
—OR—
dial 1–4 for group 1–4. “GROUP X ”
4. Select station ports (LED On = Feature Assigned)
—Station 10–57 = Dial 10–57 or press C10–C57.
5. Dial ✳ for next group
—OR—
dial ✳✳for next station feature
—OR—
dial ✳✳✳for configuration mode.
To remove station from call pickup group, assign it to group 0.
Digital Telephone System IMI66–107
3 – 62 System Programming
To Next Page
Loading...