Comdial G0408 - Assign Toll Restriction Override (TRO) Code

3.19.7 Assign Toll Restriction Override (TRO) Code
Description: The TRO feature allows users to override the toll restriction that they encounter at other
stations with their own station’s toll restriction assignments. In programming for this
feature, create a four-digit TRO code that users can dial to override the toll restrictions of
any station that they happen to be using and replace it with a toll restriction that matches
their home station.
NOTE: The system marks outgoing line calls that users make after entering a TRO code with a (T) in
its SMDR/SMDA printouts. The station number that it prints is that of the overriding station
and not the actual station that the call was made from.
To Program: 1. Dial 53 for station features. “STATION FEATURES”
2. Dial 25 for toll restriction override codes. “TOLL R. OVERRIDE”
NOTE: If you are programming with a DSS/BLF console, notice that it’s status LEDs turn on to
indicate stations that have an assigned TRO code (C10–C57 = station ports 10–57).
3. Select station port
—Station 10–57 = dial 10–57 or press C10–C57
(LED flashes = selected station port, display shows TRO if assigned).
4. Type four-digit TRO code. “NNNN ”
5. Repeat steps 3 and 4 for next station port.
6. Dial ✳ for configuration mode.
To remove a TRO code, repeat steps 1 through 3, select station port, press #.
Digital Telephone System IMI66–107
3 – 152 System Programming