3.12.4 DISD Incoming Rings
Description: The number of rings that occur on a DISD line before it is answered is programmable.
Setting a large number of rings allows time for a call to be serviced in a regular manner
by stations that have line appearance for the DISD line if such action is desired.
To Program: 1. Dial 45. “DISD RINGS”
2. Press program button to choose operating mode
—Dial 1 or press A1 = normal mode “DISD RINGS DAY X”
—Dial 2 or press A2 = night transfer (of ringing) mode. “DISD RINGS NITE X”
3. Select rings to occur before line is answered
—Dial 0 for no rings (disables DISD for the line)
—Dial 1–9 = rings 1–9.
4.
Dial
#.
5. Assign line ports to have designated ring (LED On = Assigned)
—Line port 1–14 = Dial 01–14 or Press A1–A14
—Line port 15, 16 = Dial 15, 16 or Press B1, B2
—Line port 17-24 = Dial 17-24 or press HOLD then press A1–A8.
6. Press ✳ and repeat steps 2 and 3 for further DISD ring assignment
—OR—
press ✳✳for configuration mode.
To change setting, repeat procedure and make different selection.
3.12.5 Enable/Disable Call Waiting Tone
Description: The call waiting tone sent to the called party can be enabled or disabled.
To Program: 1. Dial 17 for system features. “SYSTEM FEATURES”
2. Dial 11 for DISD call waiting tone. “DISD CALL WAIT”
3. Press A1 to toggle between enable and disable
—OR—
Dial 1 to enable call waiting tones.
Dial 2 to disable call waiting tones.
6. Press ✳ for further system features
—OR—
press ✳✳ for configuration mode.
Digital Telephone System IMI66–107
3 – 104 System Programming
To Next Page
Loading...