3.7.3 Audible Monitoring
The DSS/BLF at a multiline station provides a visual indication of idle, busy, and ringing status of the
monitored stations. You can also provide audible indication of direct and delayed ringing for selected
stations; however, you must first enable the station monitoring feature on a system-wide basis.
Enable Audible Monitoring
Description: Enable audible monitoring on a system-wide basis using this feature.
To Program 1. Dial 20. “MONITOR XXXXXXX”
2. Press A1 to switch between enable and disable (LED On = Enable)
—OR—
dial 1 to Enable “MONITOR ENABLED”
dial 2 to Disable. “MONITOR DISABLED”
3. Dial ✳ for configuration mode.
To change setting, repeat procedure and make opposite selection.
Assign Audible Monitoring To Stations
Description: Once you have enabled audible monitoring system wide, you must select each station and
the type of audible monitoring that you want to program.
To Program: 1. Dial 53. “STATION FEATURES”
2. Dial 20. “AUDIBLE MONITOR ”
3. Select monitoring type.
—Dial 1 for no audible monitoring “NONE”
—Dial 2 for direct ring monitoring “DIRECT RING”
—Dial 3 for delayed ring monitoring. “DELAYED RING ”
4. Select stations ports (LED On = Feature Assigned)
—Station 10–57: Dial 10–57 or press C10–C57.
5. Dial ✳ next monitoring condition
—OR—
dial ✳✳for next station feature
—OR—
dial ✳✳✳for configuration mode.
To change setting, repeat procedure and make different selection.
IMI66–107 Digital Telephone System
System Programming 3 – 51
To Next Page
Loading...