3.19.2 Programming Toll Restriction Table Entries
To Program: 1. Dial 71. “TOLL TABLE”
2. Dial 01–16
—OR—
press A1–A14, B1, B2 for toll table 1–16. “XXXXX TABLE Y”
3. Establish an allow or a deny table (A1 LED on = allow, A2 LED On = deny)
—Dial 5 or press A1 for allow “ALLOW TABLE Y”
—Dial 6 or press A2 for deny. “DENY TABLE Y”
4. Dial 1–4 or press A8–A11 for entry number 1–4. “XXXXXX”
5.
Dial
# to clear current entry.
6.
Dial keypad digits (0–9,
#) to enter numbers. “XXXXXX ...”
7. Dial ✳ for next entry and repeat steps 4–6 until all table restrictions are entered.
8. Dial ✳✳for next table and repeat steps 2–7 until all tables are entered.
9. Dial ✳✳✳for configuration mode.
To change setting, repeat procedure and make different selection.
IMI66–107 Digital Telephone System
System Programming 3 – 149
To Next Page
Loading...