3.7.28 System Alarm Report Stations
You can program the system to report any system alarms to designated stations.
Enable Alarm Reporting
Description: If you arrange the system to report alarms, also use this programming feature to enable
stations to display alarm reports after the station user takes appropriate action.
To Program: 1. Dial 28. “ALARM REPORTS ”
2. Press A1 to toggle between enable and disable (LED On = Enable)
—OR—
dial 1 to enable
dial 2 to disable.
3. Dial ✳ for configuration mode.
To change setting, repeat procedure and make different selection.
Select Alarm Reporting Stations
Description: After you turn on the alarm reporting feature, use this procedure to select the alarm
reporting station.
To Program: 1. Dial 53. “STATION FEATURES”
2. Dial 28. “ALARM RECEIVE ”
3. Select station ports (LED On = Selected)
—Station 10–57: Dial 10–57 or press C10-C57.
4. Dial ✳ for next station feature
—OR—
dial ✳✳for configuration mode.
To clear current setting, repeat procedure.
IMI66–107 Digital Telephone System
System Programming 3 – 77
To Next Page
Loading...