To Program: 1. Dial 76. “CALL COST TBL ”
2. Dial table number (01–33). “CALL COST TBL XX”
3. Dial 1 to enter matching digits. “XXXXXXXX ”
NOTE: Call Cost Table 1 will not accept matching digits.
4. Dial # to clear previous digits.
5. Dial matching digits for costed number
(16 max. # = match anything digit). “XXXXXXXX ”
6. Dial ✳ to end matching digits.
NOTE : Dialing a 00 or a 000 as an entry in steps 7, 9, 11, and 13 will clear the
current entry for those steps.
7. Dial 2 then dial 01–99 for Tier 1 time in tenths of minutes. “TIER 1 TIME XX ”
8. Dial ✳.
9. Dial 3 then dial 001–999 for Tier 1 rate in cents. “TIER 1 RATE XXX ”
10. Dial ✳.
11. Dial 4 then dial 001–999 for Tier 2 rate in cents. “TIER 2 RATE XXX ”
12. Dial ✳.
13. Dial 5 then dial 001–999 for surcharge rate in cents. “SURCHARGE XXX ”
14. Dial ✳✳to program next call cost table and repeat steps 2-14 until all tables are
entered.
15. Dial ✳✳✳for configuration mode.
To change setting, repeat procedure and make different selection.
Digital Telephone System IMI66–107
3 – 128 System Programming
To Next Page
Loading...