Commodore MPS 1200 - Page 240

International characters, 3-29, B-9
Italic print, 3-1S
Justified printing, 3-14
LF switch, l-S, 1-11
Line feeds, 4-2
Variable line feeds,
4-11
Line spacing, 4-4
Fixed line spacing, 4-4
1/6" line spacing, 4-4
liS" line spacing, 4-5
7/72" line spacing, 4-6
Variable line spacing,
4-6
n172" line spacing, 4-6
n/144" line spacing, 4-7
n/216" line spacing, 4-8
Secondary address,
6, 4-S
Literal characters, 2-13
Loading paper, 1-10, 1-14, 1-16
Local print mode, 9-1
Maintenance self-test, 1-19
Margins, 3-15, 4-14
Left margin, 4-17
Right margin, 4-1S
Top and
bottom margin, 4-14
Master commands, 3-23
Master graphics command, 6-S
Master pitch, 3-24
Master print mode, 3-26
Master reset, 3-23, 9-4
Near letter quality (NLQ) print,
3-1
New,page (form feeds), 4-11
Nine-pin graphics, 6-10
On-line switch, I-S
OPEN,2-5
Page length, 4-12
Set by inches, 4-13
Set by lines, 4-12
Paper, 1-9
Bottom-feed, 1-16
Continuous, 1-14
Single sheets, 1-10
Thickness, 1-17
Paper feed knob, 1-6
Paper guide, 1-4, 1-7
Paper
out light, 1-8
Paper
out sensor, 1-5, 9-S
Paper select lever, 1-7, 1-10
Paper thickness lever, 1-7, 1-17
PETASCII codes, 2-4, Appendix B
Pica pitch, 3-5
Pitch,3-5
Compressed, 3-9
Elite, 3-6
Expanded, 3-7
Pica, 3-5
Platen, 1-6
Power light, l-S
Power switch, 1-6
Print density, 3-16
Doublestrike print, 3-16
Emphasized print, 3-17
PRINT#,2-6
Printer cover, 1-5
Printer components, 1-6
Paper feed knob, 1-6
Paper guide, 1-4, 1-7
Paper select lever, 1-7
Pa per thickness lever, 1-7, 1-17
Platen, 1-6
Power switch, 1-6
Printer cover, 1-5, 1-7
Print head, 1-3, A-3
Printer installation, 2-10
Printer location,
1-1
Printer maintenance, A-I
Printer self-test,
I-IS
Proportional print, 3-12
Proportional spacing, 3-13
Quote mode, 9-2
Ready light, 1-8
Resetting the printer, 2-14
Reverse print, 3-20
Ribbon cartridge, 1-3, A-3
Saving character designs, S-4
Secondary addresses, 2-7, 4-S, 4-13
Self-tests
Maintenance self-test, 1-19
Printer self-test,
I-IS
Serial connection, 1-20, E-2
Setting up your printer,
1-1
Slashed zero, 9-S
Software,
2-11
Choosing the right configuration, 2-11
Literal characters, 2-13
Spreadsheets, 2-14
Word processors, 2-13