Loading
Continuous
Paper
Continuous
paper can be loaded
through
the rear
of
the printer
or
through
the
bottom
of
the printer.
Here's
how
to load
continuous
paper
from
the rear
of
the printer
just
below
the platen:
1.
Remove
or
lean the
printer
cover forward.
2.
Turn
the
power
switch
off
and slide the
print
head to the left.
3.
Move
the paper select lever forward and
open
the tractor covers.
4.
Flip the locking levers
forward
and
move
the tractors to the
approximate
positions for the paper
width.
Adjust the paper
supports
so they are evenly spaced.
5.
Place a stack
of
paper
on
a level surface
behind
the printer.
Bring
the
top
sheet
of
the
paper
forward
and insert it into the platen,
as
you
would
insert a single sheet.
6.
Turn
the paper
knob
until the paper advances past the metal
ribbon
guide.
Move
the paper release lever back to the
PIN
position (allowing the
paper
to be
moved
freely).
7.
Fit the
punched
holes
on
the paper
onto
the pins
on
the tractors,
moving
the tractors to
accommodate
the
width
of
the paper.
Close the tractor covers to
hold
the paper in the pins.
8.
Turn
the paper feed
knob
until the perforation
of
the paper
is
lined up
with
the
top
of
the ribbon guide.
This
will assure that
you
always start
printing
at the
top
of
the
next
page.
1-14
To Next Page
Loading...
