Commodore MPS 1200 - Page 34

The MPS 1200 has two "modes" which determine how it reacts to
different
printer control codes, Commodore mode and Epson
mode. When the
switch is set to the OFF position, the MPS 1200
behaves like a
Commodore 1525 or MPS 803 printer. With DIP
switch 1-3 set to ON, the MPS 1200 emulates an Epson FX printer.
Most characters, commands and escape sequences are common to
the two modes, so how you set this switch will depend on your
exact needs. As you read further into this manual, you'll see more
of what the differences between these modes are. The factory
setting for this
switch is OFF, in the Commodore mode.
1-24