CommScope Era CAP M 9 - Attaching a Hybrid Fiber Splice Box for a Dual Mount Installation

Era
™
Medium Power Carrier Access Point Installation Guide M0201AJB
Page 40 © October 2018 CommScope, Inc.
Installing CAP Ms
3 Followthestepsin"UnpackandInspecttheCAPMandOptionalAccessories”onpage19.Table9liststhe
partsthatshipwiththeCAPMPoleMountingKitforUpto18"Poles.
4 Referto"DeterminetheMountingSite”onpage16todeterminethemountinglocation,whichmustbe
abletosupporttheweightanddimensionsoftheCAPM.
5 Referto"MountingOrientation”onpage24todeterminethemountingorientationoftheCAPM.
6 Refertoandobserveallcautionslistedin"GeneralMountingCautions”onpage23.
7 AttacheitheraSingle
MountingBracket
(CommScopePN
7821955-xx)oraDual
MountingBracket
(CommScopePN
7821954-xx)tothetwo
screwpinsononeofthetwo
Pole-MountingBrackets.
AttachtheM6nutand
washersintheordershown.
a SlideoneM6plain
washer(7A)overeach
screwpin.
b SlideoneM6split-lock
washer(7B)overeach
screwpin,nexttotheM6
plainwasher.
c SecureoneM6Hexagon
Nut(7A)totheendof
eachscrewpin,andthen
torqueto11N-m.
8 RepeatStep7onthesecondPole-MountingBracket.
Table 9. Parts List for CommScope PN 7692096-XX
Description Quantity Description Quantity
Pole-Mounting Bracket
2 M8 Threaded Bolt 8
Bracket 2 M8 Hexagon Nut 8
M6 Hexagon Nut 4 M8 Plain Washer 16
M6 Plain Washer 4 M8 Split-Lock Washer 8
M6 Split-Lock Washer 4 M8 Nut 8
Installer must verify that the mounting surface will safely support the combined load of the electronic
equipment and all attached hardware and components.
The balance of this procedure may require two installers to complete.
Pole-Mounng
Brackets
Dual-Mounng
Bracket
7c
7a
7b
Screw
pin