DEEP LEARNING PLUS USER MANUAL
30
4. Configure the Intrusion Detection parameters as desired:
a. Video Source: Select a desired channel for Intrusion Detection.
b. Name: Enter a custom Intrusion Detection Trigger preset name.
c. Target Object: Select an object type for detection (person/bike/car).
At least one target object must be selected.
d. Ignore Duplicate Event: If selected, the DL PLUS device will ignore new events that
occur when a new object intrudes within the specified Ignore Duplicate Event Interval.
In other words, only the first object that enters the specified zone will trigger an event
and new events will only be detected after the time interval elapses.
e. Ignore Duplicate Event Interval: Select the time interval that must elapse before new
events are detected (1/5/15/30/60 minutes).
f. Advanced Setup: If selected, additional configuration options will appear.
g. Intrusion Label: Enter a custom label for the on-screen Intrusion Detection counter
widget. Note: this label only displays on DL PLUS live video (web/HDMI display output).
h. Count Reset: Select a time for resetting the Intrusion Detection counter, or manually
reset the counter.
i. Ignore Static Object: If turned on, this can help reduce incidence of false alarms by
only triggering when a moving object is detected. Events can still occur if a static
object suddenly begins moving.
5. If desired, import an existing detection rule zone. Or, create a new zone by clicking
and dragging the corners of the yellow box. Clicking within the lines allows for multiple
manipulation points to be created to fit any polygonal area.
6. Click and drag the red widget that will display the Intrusion Detection trigger count.
7. When all parameters are configured, click <APPLY> to save the settings.
To Next Page
Loading...
