Concept Pro DEEP LEARNING PLUS - Page 50

DEEP LEARNING PLUS USER MANUAL
50
4. Configure the FTP Event Action parameters as desired:
a. Name: Enter a custom FTP Event Action preset name.
b. Host: Enter the target FTP server address.
c. Port: Enter the target FTP server port number (default: 21).
d. Passive Mode: Selected by default and recommended for all use. Uncheck if active
mode is preferred.
e. Username: Enter the FTP server username.
f. Password: Enter the FTP server password.
g. Snapshot Time Range: Select a time range for event snapshots to be included. Image
snapshots will be saved and sent for every second of the configured snapshot time
range (e.g., if set to 2 secs before and 5 seconds after each event 7 image snapshots
will be transmitted). This increases the chance of a useful image snapshot being
attached to the event notification but may result in slower transmission times.
h. Directory Name Format: Select the Basic Naming template. Select any additional
information tokens from the drop-down menu and click <ADD> to add upon an
existing or custom template.
i. File Name Format: Select the Basic Naming template. Select any additional
information tokens from the drop-down menu and click <ADD> to add upon an
existing or custom template.
j. Send Example Message: Click <TEST> to send a test FTP notification to the
configured target address to confirm the connection is working.
5. When all parameters are configured, click <APPLY> to save the settings.