-
-
-
- 39 -
-
-
-
time length is the same as the length of the waveform displayed on the screen. For example, if the
speed of a waveform is relatively fast, then it needs shorter time to record it. When recording frozen
waveforms, the system is still in the Freeze status. After completion of recording, if required, you may
select once more the waveform to be output and select “ REC ” option again to record the whole
selected waveforms. You may also record frozen waveforms by pressing the “ REC/STOP ” button on
the front panel. If the recorder does not exist, selecting the “ REC ” option can only call out the prompt
“ Recorder does not exist ” in the STATUS bar. For more detailed information about recording, please
refer to the chapter of “ Recording ” .
To Next Page
Loading...
