-
-
-
- 87 -
-
-
-
Prompt message (include general alerts) :
Message Cause Alarm Level
S P O
2
EXCEED SpO
2
measuring value exceeds the range. HIGH
PR EXCEED PR measuring value exceeds the range. HIGH
SEARCH PULSE SpO
2
module is searching for pulse. No alarm
NO PULSE
SpO
2
module cannot detect SpO
2
signal for a
long time.
HIGH
12.7
12.7
12.7
12.7 Maintenance
Maintenance
Maintenance
Maintenance and
and
and
and Cleaning
Cleaning
Cleaning
Cleaning
Care
Care
Care
Care and
and
and
and Cleaning
Cleaning
Cleaning
Cleaning
Warning
Warning
Warning
Warning
Turn
Turn
Turn
Turn of
of
of
of f
f
f
f the
the
the
the monitor
monitor
monitor
monitor and
and
and
and disconnect
disconnect
disconnect
disconnect the
the
the
the line
line
line
line power
power
power
power before
before
before
before cleaning
cleaning
cleaning
cleaning the
the
the
the monitor
monitor
monitor
monitor or
or
or
or the
the
the
the sensor
sensor
sensor
sensor
Warning
Warning
Warning
Warning
Do
Do
Do
Do not
not
not
not subject
subject
subject
subject the
the
the
the sensor
sensor
sensor
sensor to
to
to
to autoclaving.
autoclaving.
autoclaving.
autoclaving.
Do
Do
Do
Do not
not
not
not immerse
immerse
immerse
immerse the
the
the
the sensor
sensor
sensor
sensor into
into
into
into any
any
any
any liquid.
liquid.
liquid.
liquid.
Do
Do
Do
Do not
not
not
not use
use
use
use any
any
any
any sensor
sensor
sensor
sensor or
or
or
or cable
cable
cable
cable that
that
that
that may
may
may
may be
be
be
be damaged
damaged
damaged
damaged or
or
or
or deteriorated.
deteriorated.
deteriorated.
deteriorated.
Cleaning:
Cleaning:
Cleaning:
Cleaning:
Use a cotton ball or a soft mull moistened with hospital-grade ethanol to wipe the surface of the
sensor, and then dry it with a cloth. This cleaning method can also be applied to the luminotron and
receiving unit.
The cable can be cleaned with 3% hydrogen dioxide , 7% isopropanol , or other active reagent.
However, connector of the sensor shall not be subjected to such solution.
To Next Page
Loading...
Need help?
General
