Contec CMS8000 Manual

-
-
-
- 69 -
-
-
-
ECG NOISE
ECG measuring signal is
greatly interfered.
LOW
Make sure the
patient is quiet, the
electrodes are
properly connected
and AC power
system is well
grounded.
Prompt
Prompt
Prompt
Prompt messages
messages
messages
messages (include
(include
(include
(include general
general
general
general alerts)
alerts)
alerts)
alerts) :
:
:
:
Message Cause Alarm Level
HR EXCEED
HR measuring value exceeds the
measurement range.
HIGH
11.7
11.7
11.7
11.7 ST
ST
ST
ST Segment
Segment
Segment
Segment Monitoring
Monitoring
Monitoring
Monitoring
11.7.1
11.7.1
11.7.1
11.7.1 ST
ST
ST
ST Segment
Segment
Segment
Segment Monitoring
Monitoring
Monitoring
Monitoring
■ ST segment monitoring function is shutoff by default. You can switch it to ON when necessary.
NOTE: When setting ST ANALYSIS on, the monitor will select “ DIAGNOS TIC ” mode. You can set
it to “ MONITOR ” mode or “ OPERATE ” mode as required. However at this time ST value has been
severely distorted.
■ It is available to measure the variance of ST segment with ST analysis at the waveform tracks for
selected lead. The corresponding ST measurement result displays numerically at ST1 and ST2 in
the Parameter Area. The trend can be viewed with table or graphic form.
■ Measurement unit of ST segment: mv.
■ Measurement symbol of ST segment: "+" = elevating, "-" = depressing.
■ Measurement range of ST segment: -2.0 mv, ~ + 2.0 mv.
Pick the ST ANALYSIS item in the ECG SETUP menu to access the ST ANALYSIS sub-menu as shown
below.
ST
ST
ST
ST ANALYSIS
ANALYSIS
ANALYSIS
ANALYSIS menu
menu
menu
menu
Figure
Figure
Figure
Figure 11-8
11-8
11-8
11-8 ST
ST
ST
ST ANALYSIS
ANALYSIS
ANALYSIS
ANALYSIS m
m
m
m enu
enu
enu
enu
ST
ST
ST
ST analysis
analysis
analysis
analysis alarm
alarm
alarm
alarm setting
setting
setting
setting
 ST ANAL: the switch for ST analysis. Set it to ON to activate the ST analysis or OFF to disable the
ST analysis.
 ST ALM: pick "ON" to enable prompt message and data record during the ST analysis alarm; pick
"OFF" to disable the alarm function, and there will be a beside ST. ST alarm is activated when

Contec CMS8000 Specifications

General

Category	Medical Equipment
Device Name	Contec CMS8000
Type	Patient Monitor
ECG Lead Mode	3-lead or 5-lead
Resolution	800 x 600
Power Supply	AC 100-240V, 50/60Hz
Battery	Rechargeable lithium battery
Operating Temperature	5°C to 40°C
Storage Temperature	-20°C to 55°C
Display	TFT LCD
Screen Size	12.1 inches
Parameters	ECG, RESP, NIBP, SpO2, TEMP, PR
Interface	Ethernet, Nurse call
Humidity	15% to 95% non-condensing
Battery Life	Approximately 4 hours