Contec CMS8000 Manual

-
-
-
- 65 -
-
-
-
4
Leads of channel 2: refer to ① for detailed information.
5
Waveform gain of channel 2: refer to ② for detailed information.
N
N
N
N ote
ote
ote
ote
Pacemaking
Pacemaking
Pacemaking
Pacemaking signal
signal
signal
signal detected
detected
detected
detected is
is
is
is marked
marked
marked
marked by
by
by
by a
a
a
a "|"
"|"
"|"
"|" above
above
above
above the
the
the
the ECG
ECG
ECG
ECG waveform.
waveform.
waveform.
waveform.
11.5
11.5
11.5
11.5 ECG
ECG
ECG
ECG Menu
Menu
Menu
Menu
11.5.1
11.5.1
11.5.1
11.5.1 ECG
ECG
ECG
ECG SETUP
SETUP
SETUP
SETUP Menu
Menu
Menu
Menu
Pick the ECG hot key on the screen , and the following menu will popup.
Figure
Figure
Figure
Figure 11-6
11-6
11-6
11-6 ECG
ECG
ECG
ECG SETUP
SETUP
SETUP
SETUP menu
menu
menu
menu
ECG alarm setting
•
HR ALM: pick "ON" to enable prompt message and data record during the ECG alarm; pick "OFF" to
disable the alarm function, and there will be a beside “ ECG ” .
•
ALM LEV: selectable from HIGH, MED, LOW. Level HIGH represents the most serious case.
•
ALM REC: pick "ON" to enable report printing upon ECG alarm.
•
ALM HI: used to set up the upper limit of ECG alarm.
•
ALM LO: used to set up the lower limit of ECG alarm.
ECG alarm is activated when the heart beat exceeds set ALM HI value or falls below ALM LO value.
ECG alarm limits:
Max. ALM HI M in . ALM LO Step
HR ADU 300 15 1
HR PED 350 15 1
HR NEO 350 15 1
N
N
N
N ote
ote
ote
ote
Please
Please
Please
Please set
set
set
set the
the
the
the alarm
alarm
alarm
alarm limits
limits
limits
limits according
according
according
according to
to
to
to clinical
clinical
clinical
clinical condition
condition
condition
condition of
of
of
of individual
individual
individual
individual patient.
patient.
patient.
patient. The
The
The
The upper
upper
upper
upper limit
limit
limit
limit
shall
shall
shall
shall not
not
not
not exceed
exceed
exceed
exceed 20
20
20
20 beat/min
beat/min
beat/min
beat/min higher
higher
higher
higher than
than
than
than the
the
the
the patient's
patient's
patient's
patient's heart
heart
heart
heart rate.
rate.
rate.
rate.

Contec CMS8000 Specifications

General

Category	Medical Equipment
Device Name	Contec CMS8000
Type	Patient Monitor
ECG Lead Mode	3-lead or 5-lead
Resolution	800 x 600
Power Supply	AC 100-240V, 50/60Hz
Battery	Rechargeable lithium battery
Operating Temperature	5°C to 40°C
Storage Temperature	-20°C to 55°C
Display	TFT LCD
Screen Size	12.1 inches
Parameters	ECG, RESP, NIBP, SpO2, TEMP, PR
Interface	Ethernet, Nurse call
Humidity	15% to 95% non-condensing
Battery Life	Approximately 4 hours