-
-
-
- 35 -
-
-
-
4.4
4.4
4.4
4.4 SILENCE
SILENCE
SILENCE
SILENCE and
and
and
and PAUSE
PAUSE
PAUSE
PAUSE
SILENCE
Press the SILENCE button on the panel for more than 1 seconds can shut off all kinds of sounds
until the SILENCE button is pressed again. When the system is in SILENCE status, any newly
generated alarm will discharge the SILENCE status and make the system give normal status
giving audio and visual alarm.
PAUSE
Press the SILENCE button on the panel once to close all audio and visual prompt and description
about all the physiological alarms and to make the system enter ALARM PAUSE status. The rest
seconds for alarm pause is displayed in the Physiological Alarm area. And the symbol is
displayed in the System Prompt area.
The user may set up the time for Alarm Pause in the ALARM SETUP menu . Three selections are
available: 1min, 2min and 3min.
When in the PAUSE status, press the SILENCE button to restore the normal alarm status. Besides,
during PAUSE status, newly occurring technical alarm will discharge the PAUSE status and the
system will access the normal alarm status. The symbol disappears, too.
N
N
N
N ote
ote
ote
ote
Whether
Whether
Whether
Whether an
an
an
an alarm
alarm
alarm
alarm will
will
will
will be
be
be
be reset
reset
reset
reset depends
depends
depends
depends on
on
on
on the
the
the
the status
status
status
status of
of
of
of the
the
the
the alarm
alarm
alarm
alarm cause.
cause.
cause.
cause. But
But
But
But by
by
by
by pressing
pressing
pressing
pressing
SILENCE
SILENCE
SILENCE
SILENCE button
button
button
button can
can
can
can permanently
permanently
permanently
permanently shut
shut
shut
shut off
off
off
off audio
audio
audio
audio sound
sound
sound
sound of
of
of
of Lead
Lead
Lead
Lead Off/Sensor
Off/Sensor
Off/Sensor
Off/Sensor Off
Off
Off
Off alarms.
alarms.
alarms.
alarms.
4.5
4.5
4.5
4.5 Parameter
Parameter
Parameter
Parameter Alarm
Alarm
Alarm
Alarm
The setup for parameter alarms is in their me nu s. In the menu for a specific parameter, you can check
and set the alarm limit, alarm status. The setup is isolated from each other.
When a parameter alarm is off, a symbol “ ” displays near the parameter. If the alarms are turned
off individually, they must be turned on individually.
For the parameters whose alarm is set to ON, the alarm will be triggered when at least one of them
exceeds alarm limit. The following actions take place:
1. Alarm message displays on the screen as described in alarm mode;
2. The monitor beeps in its corresponding alarm class and volume;
3. Alarm lamp flashes ;
4. Store all parameter values during the alarm and 4,8 or 16 second waveform prior to and after
alarm.
5. If alarm recording is on, the recorder starts alarm recording. For further information on alarm
recording, please refer to Chapter Recording.
To Next Page
Loading...
Need help?
General
