Control Techniques UD70 User Manual

UD70
Issue code: 70nu2
Reference 7-13
FLOAT
Syntax
result = FLOAT (integer expression%
This function converts an integer variable into a floating-point variable.
Example error% = 123
result = error% / 1000
This produces an output of [result = 0] since 123 / 1000 = 0 in integer
arithmetic. To produce the correct answer, one of the operands need to be
converted to floating-point.
error% = 123
result = FLOAT(error%) / 1000
This produces the correct answer: result = 0.123result = 0.123
See also
INT instruction.
GETCHAR
Syntax result% = GETCHAR
This is a
RS485 port function which reads in a character from the RS485
communications port.
The returned value is ––11 if no characters have been received in the buffer,
otherwise the value is the
ASCII code for the character read in.
See also
PUTCHAR instruction.
GETKEY
Syntax result% = GETKEY
This is a
RS232 port function which reads in a character from the RS232
PC
communications port. This function can be used only when Toolkit
communications are disabled (see Disable Toolkit communications in
Chapter 10, Parameters).
This function can only be used if Dumb-terminal Mode is enabled (see Enable
dumb-terminal mode in Chapter 10 Parameters).
The returned value is the ASCII code of the character read in. If there is no
character, the value is ––11.
The data format of the
RS232 port is fixed as follows:
19200 baud, 8 data bits, No parity, 1 start bit, 1 stop bit.
See also
PUTKEY instruction.

Control Techniques UD70 Specifications

General

Brand	Control Techniques
Model	UD70
Category	Control Unit
Language	English