Creality CR-10 SE User Manual

4. About the Power-on Guide and User Interface
12
Print file preview
Local and USB flash disk model
files can be managed via the
print file preview interface.
Print interface
Model fan switch
Print Time
Time remaining
Press and hold on the model to select multiple models and copy them to a USB flash disk
*Up to a maximum of 3 models can be copied
Click on the model file to access its details
*Checking “Calibration" can improve print quality
The current interface is for reference only.
Due to the continuous upgrading of functions,
it shall be subject to the latest software/-
firmware UI published on the official website.

Creality CR-10 SE Specifications

General

Build Volume	300 x 300 x 400 mm
Nozzle Diameter	0.4 mm
Bed Temperature	up to 110°C
Supported Filaments	PLA, ABS, PETG, TPU
Extruder Type	Direct Drive
Filament Diameter	1.75 mm
Display	4.3-inch touch screen
Printing Speed	up to 200 mm/s
Nozzle Temperature	Up to 300°C
Connectivity	USB
Power Supply	350W
Leveling	Automatic Leveling