22
4. The Control Menu
Allows manual control of the printer temperatures and fan speed and modifying the default values used by the Printer for various
functions..
Functions available here are:
Temperature
Selecting this shows a sub-menu with the following options:
Nozzle Temperature
Sets the desired nozzle temperature to the value you set, the nozzle will heat up or cool down accordingly.
Bed Temperature
Sets the desired heated bed temperature to the value you set, the bed will heat up or cool down accordingly.
Fan Speed
Sets the cooling fan speed to the value you set.
Preheat PLA Settings (and ABS Settings)
Sets the temperatures and fan speed for the Prepare / Preheat (PLA or ABS) options. To save any changes you must select the
Storage Configuration option or the changes will be lost on powering off the printer.
Motion
Shows a Sub-menu allowing you to change a number of maximum limits for motion settings. We recommend that you do not change
any of these settings unless you know exactly what you are doing!
Storage Configuration
Permanently saves any changes you have made in the Motion menu or in the Temperature / Preheat PLA or ABS Settings, If not
saved then the next power on will restore the original values.
Read Configuration
Restores all configuration values to the ones last saved overwriting any currently changed values.
Reset Configuration
Resets all parameters to the Factory Default settings.
To Next Page
Loading...
Need help?
General
