Creality ENDER-3 V2 User Manual

23
33
2. Adjusting the V Rollers
The picture shows a 3 V Roller arrangement, Two of the rollers are fixed, just a bolt, round
spacers etc. holding the roller bearing.
Others have a nut for a spacer. This has the top and bottom holes offset from the centre so
that as the nut is turned the roller is moved into or away from the profile groove in which it
runs. This allows the pressure of the V pulley against the profile groove to be adjusted.
● If there is play present, the rollers are too slack, rotate the offset nut to tighten the roller contact so removing the play.
● If the rollers are too tight not only will they wear much faster but it can also cause sticking at various points along their travel.
To adjust
● Make sure the profile groves and the surface of the V Rollers are clean.
● Slacken the bolt securing the adjustable roller slightly, if necessary.
● Use the included spanner to rotate the hex spacer until the contact of the V rollers with the profile groove has minimal play but
is not too tight.
● Retighten the bolt.
Re-check for play and re-adjust if necessary.

Creality ENDER-3 V2 Specifications

General

Build Volume	220 x 220 x 250 mm
Layer Resolution	0.1-0.4 mm
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Bed Leveling	Manual
Extruder Type	Bowden
Power Supply	MeanWell 350W
Build Surface	Carborundum Glass
Printing Technology	FDM (Fused Deposition Modeling)
Max. Nozzle Temperature	255°C
Max. Bed Temperature	100°C
Machine Dimensions	475 x 470 x 620 mm
Machine Weight	7.8 kg
Connectivity	USB, SD Card
Supported Materials	PLA, ABS, TPU, PETG
Display Screen	4.3-inch Color LCD
Print Speed	180 mm/s