Creality ENDER-3 V2 - 2. What a Successful First Layer should look like

25
2. What a Successful First Layer should look like
The nozzle is too far away from
the build plate, the filament cannot
adhere properly
The nozzle is at the correct height
above the build plate.
The nozzle is too close to the
build plate and the filament
cannot be fully squeezed out,
which may damage the nozzle
and build plate.
The nozzle is too far from the platform.
This may cause the extruded material
to not stick to the build plate.
The nozzle is at the correct height above
the platform.
The nozzle is too close to the build plate.
This may damage the nozzle and the
build plate.
X
X